ENSONIQ DP/4 Musician's Manual page 112

96
Section 4 - Algorithms
06 - Vibrato Sample & Hold Rate
Range: 001 to 100, or Off
This parameter controls the sample rate of a sample and hold network. This is applied to the LFO
within the vibrato. When in hold (low values), it causes rhythmic chirps in the pitch of the audio
signal. Higher values will increase the number of holds per second, making the vibrato flow
more smoothly. The sample and hold function can also be turned off.
07 - Vibrato Left Delay Time
Range: 0 to 1500 ms
This parameter controls the time delay on the left regenerated delay.
08 - Vibrato Right Delay Time
Range: 0 to 1500 ms
This parameter controls the time delay on the right nonregenerated delay.
09 - Vibrato Delay Regen
Range: -99 to +99
This parameter controls the amount of positive or negative feedback applied to the regenerated
delay. The sign of the value detennines the polarity of the feedback. A value of +00 will
eliminate any feedback. This parameter controls both left and right levels.
10 -
Vibrato Left Echo Time
Range: 0 to 1500 ms
This parameter controls the echo time for the left side. Higher settings yield a deeper echo. There
are two discrete echoes, one to the left and one to the right.
11 - Vibrato Right Echo Time
Range: 0 to 1500 ms
This parameter controls the echo time for the right side.
12 - Vibrato Echo Level
Range: 00 to 99
This parameter controls the volume of the discrete echo for both the left and right sides. A setting
of 00 will eliminate any audible echo.
13- Bass Fc
Range: 0 to 1000 Hz
This parameter selects the cutoff frequency of the low shelving filter.
14- Bass EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the low shelving filter.
15 - Treble Fc
Range: 01 KHz to 16KHz
This parameter selects the cutoff of the upper frequency band high shelving filter.
16 - Treble EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the high shelving filter.
17 - EQ Input Level Trim
Range: -24 to +00 dB
This parameter allows you to adjust the input volume before the EQs to eliminate the possibility
of clipping boosted signals.
18 - Mod1 Source
19 - Mod1 Destination
20 - Mod1 Param Range Min
21 - Mod1 Param Range Max
22 - Mod2 Source
23 - Mod2 Destination
24 - Mod2 Param Range Min
25 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators in the beginning of this section.
ENSONIQ DP/4 Musician's Manual