ENSONIQ DP/4 Musician's Manual page 110

94
Section 4 - Algorithms
06 - Left/Right LFO
Range: Out-at-Phase or In-Phase
When in phase, the left and right choruses will modulate their detunes together. When out-of-
phase, the detune on the left channel will go up while the detune on the right will go down.
07 - Chorus Left Delay Time
Range: 0 to 1500 ms
This parameter controls the time delay for the left channel regen delay, and has nothing to do
with the chorus effect.
08 - Chorus Right Delay Time
Range: 0 to 1500 ms
This parameter controls the time delay for the right channel regen delay, and has nothing to do
with the chorus effect.
09 - Chorus Delay Regen
Range: -99 to +99
This parameter controls the amount of regen (regeneration) applied to the delay time taps. The
sign of the value determines the polarity of the regen.
10 -
Chorus Left Echo Time
Range: 0 to 1500 ms
This parameter controls the chorus echo time for the left side. Higher settings yield a deeper
echo. There are two discrete echoes, one to the left and one to the right.
11 - Chorus Right Echo Time
Range: 0 to 1500 ms
Controls the chorus echo time for the right side. Higher settings yield a deeper echo.
12 - Chorus Echo Level
Range: 00 to 99
This parameter controls the volume of the discrete echo for both the left and right sides. Higher
values offer louder echo, while a value of 00 will eliminate the echo. For sustained sounds, mid
echo levels yield a "poor man's reverb."
13- Bass Fc
Range: 0 to 1000 Hz
This parameter sets the cutoff frequency of the lower frequency band shelving filter.
14 - Bass EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the low shelving filter.
15 - Treble Fc
Range: 01 KHz to 16KHz
This parameter sets the cutoff frequency of the high shelving filter.
16 - Treble EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the high shelving filter.
17 - EQ Input Level Trim
Range: -24 to +00 dB
This parameter allows you to adjust the input volume of the EQs to eliminate the possibility of
clipping boosted signals.
18 - Mod1 Source
19 - Mod1 Destination
20 - Mod1 Param Range Min
21 - Mod1 Param Range Max
22 - Mod2 Source
23 - Mod2 Destination
24 - Mod2 Param Range Min
25 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators, found in the beginning of this section.
ENSONIQ DP/4 M!fsician's Manual