Editing Config Parameters - ENSONIQ DP/4 Musician's Manual

Section 2 - Getting Started
Editing Config Parameters
. Editing the parameters of a config is similar to editing the algorithm parameters in a unit -
parameter #00 is the Input Config Select,
and the remaining parameters will vary depending on
the config you select. Press the Left/Right Arrow buttons to select parameters and move the Data
Entry Knob to change the value of the active (flashing) parameter.
To edit Config parameters:
1. Press Edit .
2 If the yellow Config LED is not already on, press Config. The display shows:
Parameter Number Input Config Select
nn
LILI
1 Source Confi
12
>
I=IBCD
(Flashing)
The LED display should indicate parameter 00, which is the Input Config Select parameter,
and the current config type should be flashing in the upper line of the LCD display. (If not,
press the Left Arrow button until this is the case.)
3. If you move the Data Entry Knob now, you will select among the basic config types. When
you stop moving the knob, the DP /4 is reconfigured into the config showing on the display.
4. To edit the remaining config parameters, press the Right Arrow button to scroll to other
parameters and move the Data Entry Knob to change their values. You will find a full
discussion of all the parameters for each config type later in this manual.
• Note that editing some config parameters may cause a brief interruption in the audio output.
This is normal and is required for the system to reconfigure its signal routing.
ENSONIQ DP/4 Musician's Manual
39