Editing Dp/4 Parameters; Replacing The Algorithm In A Single Unit - ENSONIQ DP/4 Musician's Manual

Section 2 - Getting Started
Editing DP/4 Parameters
Once you have selected a preset, you can edit (or replace) the algorithm in any of the four units.
Replacing the Algorithm in a Single Unit
36
You can use Edit mode to easily replace the algorithm in one of the four units without changing
the current config or affecting what is in the other units.
To replace the algorithm in a unit:
1. Press Edit .
2.
Press Unit A, B, C, or D to select that unit for editing. The active unit's yellow LED should be
lit. The display shows:
Parameter Number Algorithm Select
"I~~~~i0%;m2_EJEEJE:JlI§EJE~~IJ:liIJ:liIJ:li~~4i
(Flashing)
Selected Unit
~:~lgorithM
Na e
Mix=50 UoluMe=99
The LED display should indicate parameter 00, which is the Algorithm Select parameter, and
the algorithm name should be flashing in the upper line of the LCD display. (If not, press the
Left Arrow button until this is the case.)
3. Move the Data Entry Knob to select among the algorithms in memory. When you stop
moving the knob, the algorithm that's showing on the display will be loaded into the Unit.
Note:
When you select algorithms in Edit mode, you are actually picking from the list
of 100 1-Unit presets. As you are moving the knob, the red LED display shows the
preset numbers of the 1 Unit presets you are loading into the unit. One second after
you've stopped moving the knob, the algorithm is loaded into the unit and the LED
display will revert to 00, indicating the first parameter of the algorithm.
4. To change the algorithm in another unit, simply press its unit button and repeat the above
steps. Note that selecting a unit which is already active causes it to become bypassed. The
red bypass LED for that unit will light. Further presses toggle out of and into bypass.
Note: If you accidentally edit the algorithm in a unit, you will lose all of the
parameter settings for the old algorithm
unless
you press Cancel- Undo to recall the
original algorithm and its parameters. You must press Undo
before
scrolling to another
parameter or leaving Edit mode.
ENSONIQ
DP/4
Musician's Manual