Source Config; Plugging In; Selecting A 4 Source Config - ENSONIQ DP/4 Musician's Manual

Section 1 - Tutorial
Plugging In for a 4 Source Config
The following examples illustrate how to make the necessary connections with the DP / 4 if you
intend to use it in a four source configuration. A four source configuration will allow you to
apply a completely independent effect to each of four incoming audio signals.
Note: If you desire to use the DP / 4 in a one source configuration with a guitar, bass,
or keyboard (to apply up to four effects to a single incoming audio signal), see the
plugging in a 1 source config diagram earlier in this section.
For PA, Studio, or Mixer (4 Source Config):
o
Amp
Left Speaker Right Speaker
Send
Inputs 1-4 DP/4
§
i
j
3
e
i \\\\\\\\
Ii 11
J7
~1 r~ r~\\\\\~
Outputs 1-4
Return
Plugging In
Using the diagram shown above, make the necessary connections.
Selecting a 4 Source Config
In order to determine how the DP / 4 routes its signal paths between the various inputs and
outputs, you must select a Config Preset .
A Config Preset is the largest type of preset in the DP / 4. It contains all the signal routing
information, such as which inputs are routed to which outputs, whether the individual units (A-
D) are run in serial, parallel, or feedback, and which units are bypassed. Additionally, a Config
Preset loads each of the units with an effect and its associated parameters.
ENSONIQ
DP/4 Musician's Manual
7