ENSONIQ DP/4 Musician's Manual page 85

Section 4 - Algorithms
11 - Diffusion 2
Range: 00 to 99
This parameter, similar to and in series with Gated Diffusion 1, performs the same way but
controls lower frequency ranges. Recommended setting is approximately 50.
12 - Decay Definition
Range: 00 to 99
Controls the rate of echo density build up in the reverb decay. Setting this parameter too high can
cause the echo density to build at a rate which exceeds the decay rate. A general rule of thumb:
Definition should not exceed the Decay Rate. We recommend settings between 25 and 50.
13 - Siapback
Range: 0 to 500 ms
Controls the delay time of an internal dry stereo signal to create a slapback. In general the
slapback is greater or equal to the Hold Time (parameter
04)
to achieve a reverse effect.
14 - Siapback Level
Range: 00 to 99
This parameter adjusts the volume of the slapback (internal dry) signal. A value of 00 would
eliminate any audible slapback.
15 - Early Reflections 1
16 - Early Reflections 2
17 - Early Reflections 3
18 - Early Reflections 4
Ranges: ·99 to +99
These parameters control four early reflection levels. Setting these levels to lower values will
produce
a
wetter sound.
19 - Left/Right Balance
Range: ·99 to +99
This parameter controls the left/right stereo balance of the gated reverb signal. A setting of -99
would offer hard left, whereas a setting of +99 would offer hard right. A setting of +00 would
place the reverb in the center of the stereo spectrum.
20 - Mod1 Source
21 - Mod1 Destination Parameter
22 - Mod1 Param Range Min
23 - Mod1 Param Range Max
24 - Mod2 Source
25 - Mod2 Destination Parameter
26 - Mod2 Param Range Min
27 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators, in the beginning of this section.
ENSONIQ DP/4 Musician's Manual
69