Rear Panel Connections - ENSONIQ DP/4 Musician's Manual

Section 2 - Getting Started
Rear Panel Connections
1) AC Line In
The supplied line cord should be connected here. The correct voltage for the DP /4 is listed with
the serial number on the rear panel. If you travel, remember the DP / 4 will only operate on the
listed voltage.
2) MIDI Thru
"Passes on" all MIDI information received by the DP / 4 to other devices. Information generated
by the DP /4 itself does not go to this jack - the Thru jack merely echoes what comes in at the
MIDI In jack.
3) MIDI Out
Sends out MIDI information to other instruments and computers when the System • MIDI
parameter "Send MIDI PrgChg + Controllers"
is
set to "ON."
4) MIDI In
This jack receives MIDI (Musical Instrument Digital Interface) information from other MIDI
instruments or computers.
5) Dual Foot Switch Jack
18
This jack supports either one or two foot switches depending on what is plugged into it:
• The recommended foot switch for use with the DP / 4 is the ENSONIQ Model SW-IO Dual
Foot Switch. The SW-IO is a dual (piano-type) foot switch with two separate pedals. When
the SW-10 is connected, the pedals can each be programmed independently to act as effect
bypass switches, to provide two separately programmable modulation sources or to select
presets.
• You can also use the optional ENSONIQ Model SW-2 Foot Switch. If you plug the SW-2 into
this jack, it can increase or decrease presets, act as an effect bypass switch, or function as a
modulation controller.
If
you are considering using a foot switch with the DP / 4, we strongly recommend the SW -10
Dual Foot Switch, which gives you the most versatility with the least compromise.
ENSONIQ DP/4 Musician's Manual