ENSONIQ DP/4 Musician's Manual page 135

.
,,""",
Section 4 - Algorithms
09 - Sidechain EQ Gain
Range: -48 to +48 dB
This parameter controls the amount of boost applied to the output signal of the high/low pass
filter. This accounts for insertion loss through those filters.
10 - HighPass Fc
Range: 4 to 8000 Hz
This parameter sets the cutoff frequency of the lower frequency band high pass shelving filter.
11 - LowPass Fc
Range: 100 Hz to 16 KHz
This parameter sets the amount of boost or cut applied to the low pass filter.
12 - Trigger Mask
Range: Off or On
This parameter enables the trigger mask function. Once triggered, the side chain detector will see
no input signal for a duration specified by parameter 13.
13 - Trigger Time
Range: 1 ms to 10.0s
This parameter sets the duration over which the side chain detector will be blacked out. This
parameter is useful for isolating the first bar of a drum track.
14 - Trigger Mask Threshold
Range: -96 to +00 dB
Sets the trigger mask threshold level. Signals that fall below this level will trigger the mask
function. The trigger mask function uses the Expander Threshold (04) as upward hysteresis.
Therefore, the Trigger Mask Threshold should always be set lower than the Expander Threshold.
15 - Expander Output Mix
Range: 00 to 99
This parameter mixes the output of the left signal (Input 1) with the output of the right signal
(Input 2). This is the output mixer which is shown in the diagram.
16 - Expander Output Gain
Range: -48 to +48 dB
This parameter sets the amount of cut (negative values) or boost (positive values) applied to the
expander oli. the output volume. We recommend a starting application of +00 dB.
17 - Mod1 Source
18 - Mod1 Destination
19 - Mod1 Param Range Min
20 - Mod1 Param Range Max
21 - Mod2 Source
22 - Mod2 Destination
23 - Mod2 Param Range Min
24 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators in the beginning of this section .
ENSONIQ
DP/4
Musician's Manual
119