ENSONIQ DP/4 Musician's Manual page 165

Section 6 - System-MIDI Mode
. . . . . . . .
. .
Show 100 (onfig
Presets=Yes
••• •••••• •••• ••••• ••••••• L,. •• _ ••
~
••
~
................ . ....... . ..... _.
~
••
~
. ....... _ ....... . .......... . . _ ••
~
• •
~
........ _ ............ . ..... . _.
~
• •
~ . ,.........I
••• ::
59 - Show 100 Config Presets
Range: No or Yes
Since the OP / 4 is a very complex unit, it is potentially confusing to first time users. Selecting a
config preset can radically reconfigure the system, which may not be what the novice user
expected while exploring the available presets, so the OP / 4 is shipped with most of the config
presets hidden away to make it easier for you to get started. Only a few basic config presets are
available, and these represent templates which set the unit up for the most common applications.
When this parameter is set to "No" (which is the default) in Select mode, the DP / 4 allows you to
select the basic config templates (in preset locations 50-61). Once a config preset is selected (by
pressing the Select button), the DP / 4 automatically takes you to Unit A for selecting presets of
that type of configuration.
In Select mode, if you want to bypass all units and not change the config preset, press the Config
button until the bypass LEOs are lit. If you do not tum the Data Entry Knob (which would select
a new config), after a brief interval, the OP / 4 will automatically put you on Unit A, taking you
out of the Select Config mode.
Note: When "Show 100 Config Presets" is set to No, the Auto-Load Preset parameter
(#55) is inoperative when selecting a Config Preset. This prevents you from
accidentally selecting unwanted configs.
Once you feel comfortable with the DP / 4, and you've taken the time to understand the
architecture by reading the manual, you are ready to reveal the rest of the config presets. Set the
"Show 100 Config Presets" parameter to "Yes." Now, in Select mode, you may still select basic
configs (in preset locations 50-61), but you can also select ROM config presets 62-99 and user
programmable RAM config presets 00-49.
Note: When this parameter is set to "Yes," the DP / 4 will not automatically send you
to Unit A when you've selected a config. You must press a Unit button before you can
select that type of preset.
Data Entr':l Knob
Response=NORMI=IL
60 - Data Entry Knob Response
Range: Fast, Normal, Slow
This parameter controls the acceleration rate of the Data Entry Knob when spinning quickly
through parameter values. The default setting is "Normal." The "Slow" setting will reduce the
size of the jumps taken by the values as the knob is rotated quickly, whereas the "Fast" setting
will make the jumps larger.
ENSONIQ DP/4 Musician's Manual
149