ENSONIQ DP/4 Musician's Manual page 102

Hide thumbs Also See for DP/4:
Table of Contents

Advertisement

86
Section 4 - Algorithms
11
-
Noise Gate Off Below
Range:
-96
to
+00 dB
This parameter sets the lower threshold level at which the noise gate shuts off the
audio.
12 -
Noise Gate On Above
Range:
-96
to
+00 dB
This parameter sets the upper threshold level at which the noise gate passes the audio. The
higher second threshold prevents false "tum ons."
13 - Gate Release Time
Range:
1 ms
to
10.0s
This parameter sets the amount of time after the signal has elapsed for the noise gate to shut
down. For a longer sustain, set
this
parameter higher.
14
-
Speaker High Pass Cutoff
Range: 4
to
1000 Hz
This parameter filters out the low frequencies of the main amp prior to the speaker. The higher
the value, the less low frequencies pass
through.
15 -
OutEQ1 Fc
Range:
100
to
9999 Hz
This parameter determines the filter center frequency of the parametric in the main amp stage.
Higher values have a brighter sound.
16 - OutEQ1 Gain
Range:
-48
to
+24 dB
This parameter adjusts the amount of boost or cut applied to the main amp parametric.
17-0utEQ1 Q
Range:
01
to
18
This parameter determines the width of the resonant peak of the filter center. While the Filter
center parameter determines where (at what frequency) this peak will occur, the
Q
setting
controls the presence of the peak.
18 - OutEQ2 Fc
Range:
100
to
9999 Hz
This parameter determines the filter center frequency of
the
second parametric in the main amp
stage. Higher values have a brighter
sound.
19 -
OutEQ2 Gain
Range:
-48
to
+24 dB
This parameter adjusts the amount of boost or cut applied
to
the second main amp parametric.
20-0utEQ2 Q
Range:
01
to
18
This parameter determines the width of the
resonant
peak of the second filter center.
21 -
Speaker Low Pass Cutoff
Range: 2.0
to
16.0 KHz
This parameter filters out the high frequencies of the
speaker.
The lower the value, the less high
frequencies pass through. This speaker filter is less selective than the speaker cabinet emulation
algorithms which are provided in the DP / 4.
22 -
Mod1 Source
23 -
Mod1 Destination
24 -
Mod1 Param Range Min
25 -
Mod1 Param Range Max
26 -
Mod2 Source
27 -
Mod2 Destination
28 -
Mod2 Param Range Min
29 -
Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this
section.
ENSONIQ DP/4 Musician's Manual

Advertisement

Table of Contents
loading

Related Products for ENSONIQ DP/4

Table of Contents