Selecting 2 Unit Presets In A 2 Source Config - ENSONIQ DP/4 Musician's Manual

-
Selecting 2 Unit Presets in a 2 Source Config
Next, we will select a 2 Source Config:
1. Press Select, then press Config.
2. Use the Data Entry Knob to choose Config Preset 55:
Section 2 - Getting Started
2 Src: stereo In
~ . . . . . . . . . . . . . . . . dry~drY dry~drY
3. Press Select again. This loads the Config Preset, changing the current Config type to 2
Source, and loading all 4 Units with the Dry (No Effect) algorithm. The DP /4 automatically
takes you to Unit A.
Now, press any of the other Unit buttons, B, C, or D. Notice that the Unit LEDs light only in
pairs - A
&
B light when you press A or B; C
&
D light when you press C or D. This is
because in a 2 Source Config, the DP / 4 is divided into 2 separate multi-processors, each with
2 Units of processing power.
Remember!
In Select mode, in a 2 Source Config, only 2 Unit Presets can be
selected. They can be selected independently for Units A & B or for C & D. The preset
will be loaded into whichever pair has its Unit LEDs lit. However, any of the
individual units can be changed in Edit mode.
4. Press A, and rotate the Data Entry Knob. Now you see the 100 2-Unit presets in the DP / 4
Memory. Press Select to load the preset into Units A & B.
5. Press C, and rotate the Data Entry Knob. You will see the same 100 2-Unit presets, except
now you are selecting them for the pair of C & D. Press Select to load the preset into C & D.
r~~~f~~~~::::::::r Eli!]
EEl
as a single device.
Only 2-Unit Presets
can be selected.
Each 2-U Preset will load
new algorithms into A & B,
or into C & D, depending on
which pair is selected.
The same 100 presets are
available to load either into
A & B or into C & D.
There are 50 ROM and 50 RAM
2-U Presets to choose from.
ENSONIQ
DP/4
Musician's Manual
2-Unit Presets
00 clYtp~dd
1
01 fla~rev
02
03
04
05
06 ... 99
33
- - -==