Tunable Speaker - ENSONIQ DP/4 Musician's Manual

Section 4 - Algorithms
TUNABLE SPEAKER
90
00 - Tunable Speaker offers an EQ controllable speaker sound which is brighter than Speaker
Cabinet. By tuning three parametric filters, you can simulate many different speaker cabinet
sounds that are used in all styles of music.
The parameters available for this algorithm are:
01- Mix
02-Volume
See the descriptions under the Mix and Volume Parameters, in the beginning of this section.
03-Mid1 Fc
Range: 100 to 9999 Hz
Sets the center of the mid-frequency parametric. Higher values have a brighter sound.
04 - Mid1 Gain
Range: -48 to +24 dB
This parameter sets the amount of cut (negative values) or boost (positive values) applied to this
mid-frequency parametric.
05- Mid1 Q
Range: 01 to 18
This parameter is a bandwidth control that determines the width of the resonant peak at the
center of the frequency band. By raising the value, you can produce a narrower bandwidth.
06-Mid2Fc
07 - Mid2 Gain
08-Mid2Q
09-Mid3 Fc
10 - Mid3 Gain
11 - Mid3 Q
These parameters are identical to the previous ones, but can be assigned to control different
bandwidths within the mid-range.
12 - Speaker Input Attenuation
Range: -24 to +00 dB
This parameter allows you to adjust the input level before the EQs to eliminate the possibility of
clipping boosted signals.
13 - Speaker Output Gain
Range: -48 to +24 dB
Since speaker cabinets are "lossy," output gain is required to compensate losses in perceived
volume. Setting this gain too high will cause clipping of the output signaL
14- Mod1 Source
15 - Mod1 Destination
16 - Mod1 Param Range Min
17 - Mod1 Param Range Max
18 - Mod2 Source
19 - Mod2 Destination
20 - Mod2 Param Range Min
21 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators in the beginning of this section.
ENSONIQ DP/4 Musician's Manual