ENSONIQ DP/4 Musician's Manual page 162

146
Section 6 - System-MIDI Mode
rn
:lU
50 - MIDI SysEx
10
MIDI SYsEx 10=01
Receive Enabled
Range: 01 to 16
This parameter sets the system exclusive ID. This number is not a MIDI channel. It is simply an
ID number imbedded within the system exclusive message. This allows usage of multiple
DP / 4' s with a universal editor librarian etc. All outgoing dumps will contain this ID number and
incoming dumps will only be received if the ID in the message matches this parameter
value.
51 - SysEx Reception
Range: Disabled or Enabled
This parameter (second line) defines whether system exclusive messages can be
received
by the
DP / 4. Outgoing dumps can always be initiated by pressing the Write-Copy button while in
System - MIDI Mode.
r'l
~C
Preset Mervaor-=-
Protect=Off
52 - Preset Memory Protect
Range: Off or On
If set to "On" this parameter will protect any RAM (user programmable) preset from being
changed or erased. It
must be set to the "Off" position in order to write an edited preset or copy a
selected preset to a new location. It must also be "Off" in order to use the system utility
command to initialize the RAM
presets.
Use the MIDI System Exclusive Receive Enable switch (parameter 51) to protect preset memory
against being unintentionally changed by incoming dumps.
MIDI Prog Change
MasterSwitch=On
53 - MIDI Prog Change MasterSwitch
Range: Off or On
This is the main program change receive switch. If it is set to "Off," all program change messages
are ignored regardless of how the individual units are set up. If it is "On," the Range in the
individual unit MIDI setups will determine whether or not program changes are recognized.
ENSONIQ DP/4 Musician's Manual
--