Selecting 1 Unit Presets In A 4 Source Config - ENSONIQ DP/4 Musician's Manual

l _
Selecting 1 Unit Presets in a 4 Source Config
Now, select a 4 Source Config:
1. Press Select, then press Config.
2. Use the Data Entry Knob to choose Config Preset 59:
Section 2 - Getting Started
Src:Stereo Out
dry dry dry
4
dry
3. Press Select again. This loads the Config Preset, changing the current Config type to 4
Source, and loading all 4 Units with the Dry (No Effect) algorithm. The DP / 4 automatically
takes you to Unit A.
Now, press any of the other Unit buttons, B, C, or D. Notice that each Unit lights
independently, and the display shows its full algorithm name. This is because in a 4 Source
Config, the DP / 4 is divided into 4 separate 1 Unit devices.
Remember! In a 4 Source Config, only 1 Unit Presets can be selected. They can
be selected independently into Unit A, B, C, or D. The preset will be loaded into
whichever unit has its Unit LED lit when you begin moving the knob.
4.
Press A, B, C, or D and rotate the Data Entry Knob. Now you see the 100 I-Unit presets in
the DP / 4 Memory. Press Select to load the preset into the currently selected unit.
Experiment with moving between the four Units and selecting 1 Unit presets for them, thinking
of each unit as an independent effects processor.
Only 1-Unit Presets
can be selected.
00 SMall ROOM Rev
The same 100 presets are
01 Large ROOM Rev
available to load into A, B, C, or D
SMall Plate
02
Press the A, B, C, or D button to
03
choose which Unit to load the preset
into.
04
Reverse Reverb
There are 50 ROM and 50 RAM 1-U
05
Presets to choose from.
06 ... 99
ENSONIQ
DP/4
Musician's Manual 35