Input Configurations; One Source Input Configuration; Two Source Input Configuration; Three Source Input Configuration - ENSONIQ DP/4 Musician's Manual

Section 3 - Config Parameters
Input Configurations
The diagram in the upper right comer of the DP /4 shows the input configurations. All of the
DP / 4 input configurations are based on this diagram:
input configurations
'0:
1~
A
~1
1
~
A
~1
A
1-1
2~
B
~2 2~
B
~2
1)
B
C
3~ ~3
0
1-2
ill
3
ill
3
C
3 0 3 0
4~ ~4
4 4
0
1 source 2 source 3
source
4 source
One Source Input Configuration
In a 1 Source Config, use Input 1 for a mono signal (such as a guitar), or Inputs 1 and 2 if your
source is a stereo signal (such as a keyboard). The choice of stereo or mono for an input is a 1
Source Config parameter, and will be covered later in this section. Remember, any mono signal
(high or low impedance) can be plugged into the jack on the front panel. The Input 1 jack (front
panel) will always override the Input 1 jack on the rear panel.
Two Source Input Configuration
In a 2 Source Config, for your first source, use Input 1 for a mono signal, or Inputs 1 and 2 if your
source is a stereo signal. For your second source, use Input 3 for a mono signal, or Inputs 3 and 4
if your second source is a stereo signal. You can choose a stereo or mono input selection for
Inputs 1 and 2 and/ or Inputs 3 and 4 using the appropriate 2 Source Config parameters, covered
later in this section.
Three Source Input Configuration
In a 3 Source Config, use Inputs 1 and 2 for two independent mono signals. For your third
source, use Input 3 for a mono signal (such as a guitar or a microphone), or Inputs 3 and 4 if your
source is a stereo signal. The choice of stereo or mono for Inputs 3 and 4 is a 3 Source Config
parameter, and will be covered later in this section.
Four Source Input Configuration
In a four source config, four separate mono sources are plugged into Inputs 1, 2, 3, and 4.
42
ENSONIQ DP/4 Musician's Manual