ENSONIQ DP/4 Musician's Manual page 116

100
Section 4 - Algorithms
08 - Left/Right LFO
Range: Out-of-Phase or In-Phase
Determines whether the flanger on the left and right channels is modulating in or out-of phase.
09 - Flanger Sample & Hold Rate
Range: 001 to 100, or Off
This parameter controls the sample rate of a sample and hold network. This is applied to the LFO
within the flanger. When in hold, the effect will be to create momentarily fixed notches within
the frequency spectrum (if the notch depth is not 00). A setting of 001 will have the largest space
between samples. Higher values will increase the number of holds per second, making the
flanging flow more smoothly. The sample and hold function can be turned off.
10 - Flanger Left Delay Time
Range: 0 to 1500 ms
This parameter controls the time delay for the left channel regen delay. This is the "ping."
11 - Flanger Right Delay Time
Range: 0 to 1500 ms
This parameter controls the time delay for the right channel regen delay. This is the "pong."
12 - Flanger Delay Feedback
Range: -99 to +99
Controls the level of the delay time taps. The sign of the value determines the polarity of the
feedback.
13 - Flanger Left Echo Time
Range: 0 to 1500 ms
This parameter controls the flanger echo time for the left side. Higher values yield a deeper echo.
14 - Flanger Right Echo Time
Range: 0 to 1500 ms
This parameter controls the flanger echo time for the right side.
15 - Flanger Echo Level
Range: 00 to 99
Controls the volume of the discrete echoes. A setting of 00 would eliminate any audible echo.
16- Bass Fc
Range: 0 to 1000 Hz
This parameter sets the cutoff frequency of the lower frequency band shelving filter.
17-EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the low shelving filter.
18 - Treble Fc
Range: 01 KHz to 16KHz
This parameter selects the cutoff of the upper frequency band high shelving filter.
19 - EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the high shelving filter.
20 - EQ Input Level Trim
Range: -24 to +00 dB
Allows you to adjust the input volume of the EQs to prevent clipping boosted signals.
21 - Mod1 Source
22 - Mod1 Destination
23 - Modl Param Range Min
24 - Modl Param Range Max
25 - Mod2 Source
26 - Mod2 Destination
27 - Mod2 Param Range Min
28 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators in the beginning of this section.
ENSONIQ DP/4 Musician's Manual