ENSONIQ DP/4 Musician's Manual page 141

Section 4 - Algorithms
08 - Comp Attack
Range: 50llS to 100ms
Determines the attack rate after the initial signal has been detected and before the compression
takes affect.
09 - Comp Release
Range: 1 ms to 10.0s
Determines how long it takes for the compression to be fully deactivated after the input signal
drops below the threshold level. This is generally set longer than the attack time (parameter 06).
10 - Noise Gate Off Below
Range: -96 to +00 dB
This parameter sets the lower threshold level at which the noise gate shuts off the audio.
11 - Noise Gate On Above
Range: -96 to +00 dB
Sets the upper threshold level at which the noise gate passes audio. This higher second threshold
prevents false "tum ons."
12 - Bass Fc
Range: 0 to 1000Hz
This parameter sets the cutoff frequency of the lower frequency band shelving filter.
13 - Bass Gain (loShv)
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the low shelving filter.
14-Mid1 Fc
Range: 100 to 9999 Hz
Sets the center of the mid-frequency parametric. Higher values have a brighter sound.
15 - Mid1 Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to this frequency parametric.
16- Mid1
Q
Range: 01 to 18
This bandwidth control determines the width of the resonant peak at the center of the frequency
band. Higher values produce a narrower bandwidth.
17- Mid2 Fc
18 - Mid2 Gain
19- Mid2
Q
These three parameters are identical to the previous three parameters, and can be used to control
different bandwidths within the mid range.
20 - Treble Fc
Range: 01 KHz to 16KHz
This parameter sets the cutoff frequency of the upper frequency band high shelving filter.
21 - Treble Gain (HiShv)
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the high shelving filter.
22 - Side Chain EQ Input Trim
Range: -48 to +00 dB
Adjusts the input level to the side chain EQ, which performs analysis on the input signal so as to
selectively compress it.
23 - Mod1 Source
24 - Mod1 Destination
25 - Mod1 Param Range Min
26 - Mod1 Param Range Max
27 - Mod2 Source
28 - Mod2 Destination
29 - Mod2 Param Range Min
30 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators in the beginning of this section.
ENSONIQ DP/4 Musician's Manual 125