ENSONIQ DP/4 Musician's Manual page 125

, -
Section 4 - Algorithms
06 - PitchShifter Vc 1 Pan
Range: -99 to +99
This parameter allows you to assign the location of output Voice 1 in the stereo field. A value of
-99 would be far left, and +99 would be far right.
07 - PitchShifter Vc 2 Semi
Range: -12 to +12
This parameter allows you to adjust the pitch of Voice 2 up to an octave above or below the
original pitch in semi-tones.
08 - PitchShifter Vc 2 Fine
Range: -99 to +99
This parameter allows you to fine tune the pitch of Voice 2.
09 - PitchShifter Vc 2 Level
Range: 00 to 99
This parameter allows you to adjust the volume of Voice 2. A setting of 00 would eliminate any
audible pitch shift.
10- PitchShifter Vc 2 Pan
Range: -99 to +99
This parameter allows you to assign the location of output Voice 2 in the stereo field. A value of
-99 would be far left, and +99 would be far right.
11 - Delay vs Quality
(Pitch Shifter 1 U Only)
Range: Long/Smoother or Short/Coarser
This parameter allows you to choose between a long/smooth setting, or a short/coarse setting. A
smooth setting would sound best with slower sustaining chords, whereas a coarse setting would
enhance a rapidly played musical passage. Depending on your sound source and musical needs,
set this parameter accordingly. This parameter actually controls the effect transport delay;
smooth yields a long transport delay, coarse yields a short transport delay.
PitchShifter LFO Rate
Range: 00 to 99
This parameter controls the rate of pitch modulation which creates a chorusing effect. To achieve
chorusing, this rate must be very low.
PitchShifter LFO Width
Range: 00 to 99
This parameter controls the excursion of pitch modulation. Since the rate is usually very low,
then the width is usually very large.
Mod1 Source
Mod1 Destination
Mod1 Param Range Min
Mod1 Param Range Max
Mod2 Source
Mod2 Destination
Mod2 Param Range Min
Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this section.
ENSONIQ DP/4 Musician's Manual 109