Air Filter Check; Air Filter And Cleaning; Assembly - Husqvarna TC 250-450-510/2007 Workshop Manual

EINSTELLUNGEN UND REGULIERUNGEN

Air filter check

Turn rear pin (1) counterclockwise, remove it and release the saddle from the front
fastening screw.
TE-SMR: Turn forward the housing box complete with the battery (it is not necessary
to remove the battery from its housing box). To gain access to the air filter, lift a little
the electronic power unit (2). Remove screw (3) and the filter (4). Separate filter (5)
from frame (6).

AIR FILTER AND CLEANING

Wash filter with a specific detergent (AGIP" Filter clean foam air detergent fluid" or
similar) then dry it fully (wash filter with gasoline only in case of necessity). Plunge
filter in special oil for filters (AGIP "Foam air filter protection oil" or similar), then wring it
to drain superfluous oil.
: Do not use gasoline or a low flash-point solvent to clean the element. A fire or
explosion could result.
: Clean the element in a well ventilated area, and do not allow sparks or flames
anywhere near the working area.

ASSEMBLY

To ensure tight fit, slightly (C) grease filter edge on side facing filter housing. While re-
inserting the filter into its housing, make surs that piece (A) is turned upwards and
edge (B) is on the left lower side of the filter case. Reassemble the parts previously
removed (battery: connect the positive cable first).
: If the element assembly is not installed correctly, dirt and dust may enter and
the engine resulting in rapid wear of the piston rings and cylinder.
After the cleaning of the air filter, also clean the filter located on the hose (a) of the
solenoid valve (b). To gain access to the solenoid valve remove the R.H. side panel.
Part. N. 8000 A8796 (03-2007)
REGISTRAZIONI E REGOLAZIONI
SETTINGS AND ADJUSTMENTS
RÉGLAGES ET CALAGES
AJUSTES Y REGULACIONES
D.33