Flasher Unit - Kubota WSM B2050 Workshop Manual

B2050, B2350, B2650, B3150, WSM

(5) Flasher Unit

Supply Voltage to Flasher Unit
1. Disconnect the connector from the flasher unit.
2. Measure the voltage between the terminal 7, 8 and chassis.
3. If the voltage differ from the battery voltage, the wiring harness
is damaged.
Key switch at
Voltage
"ON"
(Reference)
1 Turn signal switch (R)
2 Blank
3 To battery direct (beacon)
4 Turn signal switch (L)
5 Hazard switch
6 Turn signal (R)
7 ACC
8 Battery
9 Turn signal (L)
10 Beacon switch
11 Beacon outlet
12 GND
13 Trailer indicator
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 85 to 95 flashers for a minute.
2. Set the key switch to the ON position and move the turn signal
switch to the left. Make sure the left-hand light gives flashes.
Then move the turn signal switch to the right and make sure the
right-hand light gives flashes. Make sure the same actions as
above result.
3. If both the hazard switch and the turn signal switch function but
the above actions do not take place, replace the flasher unit with
new one.
(1) Flasher Unit
(2) Flasher Unit 13P Coupler
9-S28
ELECTRICAL SYSTEM
Terminal 8 – Approx. battery
Chassis voltage
Terminal 7 – Approx. battery
Chassis voltage
1 to 13:Terminals
[A] ROPS Model
[B] CABIN Model
9Y1210982ELS0056US0
KiSC issued 03, 2014 A