Hydraulic Unit; 3-Point Hitch Control System; Position Control - Kubota L3540 Operator's Manual

70

HYDRAULIC UNIT

HYDRAULIC UNIT
The tractor has 5 hydraulic control systems as shown
below. Therefore, use the most appropriate system for the
implement you are using.
C 3-Point Hitch Control System

1. Position Control

2. Draft Control (if equipped)
3. Mixed Control (if equipped)
4. Float Control
C Remote Hydraulic Control System
A Do not operate until the engine is warmed up. If
operation is attempted when the engine is still cold, the
hydraulic system may be damaged.
A If noises are heard when implement is lifting after the
hydraulic control lever has been activated, the
hydraulic mechanism is not adjusted properly. Unless
corrected, the unit will be damaged. Contact your
KUBOTA Dealer for adjustment.

3-POINT HITCH CONTROL SYSTEM

To avoid personal injury:
A Before using the 3-point hitch controls, ensure
that no person or object is in the area of the
implement or 3-point hitch. Do not stand on or
near the implement or between the implement
and tractor when operating the 3-point hitch
controls.
BPosition Control
This will control the working depth of 3-point implements
regardless of the amount of pull required.
Place the draft control lever in the lowest position and set
the implement working depth with the position control
lever.
(1) Position control lever
(2) Draft control lever [if equipped]
A Do not hold the position lever at the raised position, or
the relief valve continues to work and that will possibly
cause the pump and relief valve damage.
(1) Position lever (A) In case of taking the oil out of
(2) Bolt
(3) Spring holder
(A) "UP"
(B) "DOWN"
(C) "FLOAT"
the hydraulic cylinder head