Kubota WSM B2050 Workshop Manual page 38

B2050, B2350, B2650, B3150, WSM
Checking Head Light, Hazard Light etc.
1. Inspect the light for broken bulbs and lenses.
2. Replace if broken.
Checking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS attaching
hardware before operating tractor.
2. Replace if damaged.
Checking Clutch Pedal [ROPS Manual Transmission Type]
1. Inspect the clutch pedals for free travel, and smooth operation.
2. Adjust if incorrect measurement is found: (See "Adjusting
Clutch Pedal" in "EVERY 100 HOURS".)
Checking Parking Brake Lever
WARNING
To avoid personal injury or death:
• Stop the engine and chock the wheels before checking
parking brake lever.
Proper parking brake lever free travel
1. Please raise the lever to the parking position while counting the
ratchet sound made by the parking brake lever.
(1) Parking Brake Lever
Checking and Cleaning of Electrical Wiring and Battery Cables
WARNING
To avoid personal injury or death:
• A loosened terminal or connector, or damaged wire may
affect the performance of electrical components or cause
short circuits. Leakage of electricity could result in a fire
hazard, a dead battery or damage to electrical components.
• Replace damaged wires or connections promptly.
• If a fuse blows soon after replacement, DO NOT USE A
LARGER THAN RECOMMENDED FUSE OR BYPASS THE
FUSE SYSTEM.
• Many wiring connections are protected by waterproof
plugs, plug and unplug these connections carefully and
make sure they are sealed correctly after assembly.
• Accumulation of dust, chaff or spilled fuel deposits around
the battery, electrical wiring, engine or exhaust system are
a fire hazard.
CLEAN THESE AREAS BEFORE STARTING WORK.
To avoid premature electrical malfunctions DO NOT APPLY
high pressure water directly to battery, wiring, connectors,
electrical components or instrument panel.
Inspect the following regularly:
1. Check wiring for chafed or cracked insulation.
2. Check wiring harness clamps. Replace if necessary.
3. Check connectors and terminals for looseness, contamination
or overheated (discolored) connectors.
4. Check instrument panel for correct operation of switches and
gauges.
G-17
GENERAL
9Y1210982GEG0016US0
9Y1210982GEG0017US0
9Y1210982GEG0018US0
2 notches (Ratchet sound 2)
(A) "PULL"
9Y1210982GEG0019US0
9Y1210982GEG0020US0
KiSC issued 03, 2014 A