Kubota WSM B2050 Workshop Manual page 265

B2050, B2350, B2650, B3150, WSM
PTO Shaft
1. Remove the thrust bearing (6) and the PTO shifter (4) not to
damage the seal rings (5) located at the PTO shaft front side.
2. Remove the seal rings (5) located at the PTO shaft rear side.
3. Remove the ball bearing (2) with a puller.
(When reassembling)
• Check all seal rings (5).
• If the seal ring (5) is damaged, replace it.
• Check the direction of the thrust bearing (6) and install the thrust
bearing (6) as shown in the picture.
(1) PTO Clutch Shaft
(2) Ball Bearing
(3) 26T Mid-gear
(4) PTO Shifter
3-S53
TRANSMISSION
(5) Seal Ring
(6) Thrust Bearing
(7) Needle Bearing
(8) Collar
9Y1210982TRS0084US0
KiSC issued 03, 2014 A