Rear Bearing Carrier - Polaris Ranger RZR XP 900 2011 Service Manual

FINAL DRIVE
6. Connect the AWD wire harness.
7. Refer to "FRONT DRNE SHAFT - Drive Shaft
Installation" and install both front drive shafts into the
gearcase.
8. Add the proper lubricant to the front gearcase. Refer to
Chapter 2 for fluid fill and change information.
Recommended Front Gearcase Fluid:
Polaris Demand Drive Plus
(PN 2877922) (Quart)
Capacity: 6.75 oz. (200 ml)
7.22
REAR BEARING CARRIER
Bearing Carrier Inspection
I
Removal
1. Elevate rear of vehicle and safely support machine under
the frame area.
A
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping the top and bottom
of the tire firmly and checking for movement. The tire
should rotate smoothly without binding or rough spots.
3. Remove the (4) wheel nuts and remove the rear wheel.
4. Remove the cotter pin and loosen the rear wheel hub castle
nut. Remove the nut, and (2) cone washers from the rear
wheel hub assembly.
5. Remove the lower radius rod outer mounting bolt, nut and
washer from the bearing carrier. Swing radius rod down.
Discard the nut.
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.