Headlight Adjustment; Headlamp Replacement - Polaris Ranger RZR XP 900 2011 Service Manual

ELECTRICAL
HEAD LIGHTS
Headlight Adjustment
The headlight beams are adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
6. Adjust the beam to desired position. Repeat the procedure
to adjust the other headlight.
A
WARNING
Due to the nature of light utility vehicles and
where they are operated, headlight lenses
become dirty. Frequent washing is necessary to
maintain lighting quality. Riding with poor
lighting can result in severe injury or death.
25 ft.
(7.6m)
~ 2" (Scm)
~
' - - - - - - - I
I
I
I
I
Headlamp Replacement
IMPORTANT: If an LED headlamp has fogging or
moisture inside, disconnect the headlamp(s) for a few
days to allow the moisture to clear out.
1. Disconnect the wire harness from the headlamp assembly.
Be sure to pull on the connector, not on the wiring.
2. Measure the distance from the floor to the center of the
headlight and make a mark on the wall at the same height.
3. With the machine in Park, start the engine and tum the
headlight switch to the LOW position.
4. The most intense part of the LOW beam headlight beam
should be aimed 2 in. (5 em) below the mark placed on the
wall in Step 2.
NOTE: Rider weight must be included in the seat
while performing this procedure.
5. Adjust the beam to the desired position by loosening or
tightening the (3) T-25 adjustment screws and moving the
lamp to the appropriate height.
2. Remove the (3) T-25 headlamp mounting screws and (3)
adjustment preload springs.
NOTE: The front bumper can be removed and
placed face down on a suitable workbench to ease
headlamp replacement (see Chapter 5).
10.14-----------------------
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.