Polaris Ranger RZR XP 900 2011 Service Manual page 288

TRANSMISSION
13. Remove the (4) bolts attaching the upper and lower radius
rods to the bearing carriers (left and right side). Discard nuts
and replace with new upon assembly. Allow the radius rods
swing downward.
14. Remove both lower shock bolts (left and right side) while
supporting the trailing arms from underneath. Lift training
arms up and swing trailing arms outward to remove the
drive shafts from the transmission.
15. Maneuver the drive shafts out of the vehicle frame.
Reinstall the lower shock bolts to hold the trailing arms up
during the rest of the removal procedure.
16. Place a spacer or support between the vehicle frame and
engine to hold the engine up in position.
17. Remove vent hose from transmission.
18. Remove the gear position switch connector (A), speed
sensor connector (B), harness from routing clip (C), shift
bracket bolts (D), shift bracket (D), shift cable clevis pin
and washer (E) from the transmission.
19. To remove the through-bolts: Hold through-bolt firmly in
position with an open ended wrench from the left hand side
of the transmission. From the right hand side of the
transmission, remove the nut that secures through-bolt.
8.6
Transmission
Nut (2)
Through-bolts
~
~~~
.
--~:;~J;;>
~....-,,-
~/ ~
Threaded Spacer
Jam Nut
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.