Polaris Ranger RZR XP 900 2011 Service Manual page 97

7. Remove the sump cover (D) from the crankcase.
ENGINE I COOLING
11. Lift the oil pump drive chain and remove the oil pump.
I
8. Remove and clean oil pump pick-ups (E).
9. Remove the (3) bolts (F) that retain the oil pump (G) to the
crankcase.
10. Use one of the oil pump retaining bolts or a pen magnet to
extract the dowel pins (H) from the oil pump. Doing so
allows for oil pump removal without having to remove the
pump drive sprocket.
NOTE: If unable to extract the dowel pins from the
oil pump, the oil pump sprocket must be removed.
Access the sprocket bolt by removing the case plug.
12. Visually inspect the oil pump and drive sprocket (1) for
wear or damage. Replace oil pump drive chain and sprocket
ifwom or damaged. If any part ofthe oil pump is damaged,
the entire assembly must be replaced. Replace the oil pump
seal (J) during crankcase assembly.
NOTE: Oil pump assembly is non-serviceable
13. Rotate the engine so the cylinder is facing up.
14. Remove the (11) M6 and (2) M8 upper crankcase bolts.
15. Rotate the engine so the cylinder is facing down.
3.45
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.