All Wheel Drive Coil - Polaris Ranger RZR XP 900 2011 Service Manual

ELECTRICAL
ALL WHEEL DRIVE COIL
Operation Overview
• When the key switch is "ON", 12 VDC power is present
at the hub coil.
• When the AWD switch is "ON", and if the criteria is
met, the Engine Controller provides a ground path
(brown/white wire). When this occurs the AWD icon
should display in the instrument cluster.
• The AWD system must be grounded to operate.
Diagnosing System Failures
• Verify the AWD switch is functional and that a
minimum of 11 volts is present at the hub coil.
• Verify the AWD hub coil is functional. Test the AWD
hub coil using an ohm meter. See specifications below:
II VOLTS MINIMUM REQUIRED
TO POWER HUB COl L
8_
Test Resistance
Readings should be:
GY to BNIWH: - 24 Ohms
GY to Ground: No Connection
~
i
L
----
•
• Verify the wiring harness, wiring, connectors, connector
pins and grounds are undamaged, clean and connect
properly.
• Verify continuity of wire connections with a known
good volt/ohm meter.
IMPORTANT: Verify all wires and wiring connections
have been tested properly with a known good voltl
ohm meter before suspecting a component failure.
80% of all electrical issues are caused by bad/failed
connections and grounds.
I
- - - - - - - - - - - - - - - - - - - - - - - 1 0 . 1 3
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.