Drive Belt - Polaris Ranger RZR XP 900 2011 Service Manual

CLUTCHING (PVT)
13. Install the drive belt noting direction of belt rotation (see
"DRIVE BELT - Belt Installation"). If a new belt is
installed, install so numbers can be easily read.
14. Install a new outer clutch cover seal with the colored stripe
facing the inner clutch cover.
15. Reinstall outer clutch cover and secure with screws. Torque
screws to specification.
e
=T
Outer Clutch Cover Retaining Screws:
45-50 in. Ibs. (5.5 Nm)
16. Install the clutch inlet and outlet ducts and tighten the hose
clamps.
17. Install the left rear shock lower mounting bolt and the left
rear wheel. Torque fasteners to specification.
e
=T
Rear Shock Mounting Bolt:
70 ft. Ibs. (95 Nm)
e
=T
Wheel Nuts:
30 ft. Ibs. (41 Nm) + 90° (1/4 turn)
18. Install engine service panel and both seats.
6.8
DRIVE BELT
Belt Removal
IMPORTANT: Inspect the entire clutch outlet duct
(including the outlet duct screen) when replacing a
drive belt. Remove any debris found in the outlet duct
or outlet duct screen.
1.
Remove the (8) screws that retain the outer clutch cover.
2. Maneuver the outer clutch cover outward as shown below
to access the drive belt.
NOTE: Removal of left rear wheel or left rear shock
is NOT necessary for belt replacement.
3. Mark the drive belt direction of rotation so that it can be
installed in the same direction.
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.