Polaris Ranger RZR XP 900 2011 Service Manual page 71

7. Rotate water pump drive tab so it matches the angle of the
drive slot in the engine.
ENGINE I COOLING
12. Install the (5) coolant hoses that attach to the water pump.
Be sure orientation and routing are correct.
Oil Cooler Oil Cooler
Outlet Hose Inlet Hose
I
A
CAUTION
The water pump drive tab and slot must be aligned
properly during installation. Severe engine or water
pump damage will occur if the tab and slot are not in
alignment during water pump installation.
8. Maneuver water pump up through the access hole in the
skid plate on the RH side ofthe vehicle.
9. Slide water pump into engine crankcase.
10. Be sure water pump is fully seated and the drive tab and slot
are properly engaged.
11. Install the (3) water pump mounting bolts and torque to
specification.
C
=T
Water Pump Mounting Bolts:
89
±
9 in. Ibs. (10
±
1 Nm)
13. Install the right rear lower shock bolt and new nut. Torque
mounting bolt to specification.
C
=T
Rear Shock Mounting Bolts:
70 ft. Ibs. (95 Nm)
14. Install the right rear wheel. Torque wheel nuts to
specification.
C
=T
Wheel Nuts:
30 ft. Ibs.
(41 Nm) + 90° (1/4 turn)
15. Connect the (-) negative battery cable.
16. Fill and bleed cooling system as outlined in this chapter.
17. Install hood, engine service panel and seats (Chapter 5).
Longer Bolt
~
NOTE: The top bolt is longer than the lower bolts.
3.19
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.