Engine Disassembly I Inspection - Lower End; Stator Cover Removal/Inspection - Polaris Ranger RZR XP 900 2011 Service Manual

ENGINE
I
COOLING
ENGINE DISASSEMBLY I INSPECTION - LOWER END
Stator Cover Removal/Inspection
NOTE: The stator cover can be removed with the
engine installed in the chassis.
1. Remove the (13) screws retaining the stator cover.
A
CAUTION
The flywheel contains powerful magnets. Use
caution when removing and installing the stator
cover. DO NOT place fingers between cover and
crankcase at any time during the removal /
installation process or injury could result.
2. Carefully pry the stator cover off the engine using the two
pry areas as shown below.
3. Inspect the condition ofthe stator windings (A) and output
wires (B). If replacement is required, refer to Chapter 10.
4. Inspect the ball bearing (C) that supports the starter motor
shaft.
5. If bearing replacement is required, remove the retaining
ring and heat the stator cover around the bearing evenly
with a heat gun. Tap cover on a soft work surface to remove
the bearing from the housing. A blind bearing puller can
also be used. Replace bearing if removed.
3.40
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.