Front Bearing Carrier - Polaris Ranger RZR XP 900 2011 Service Manual

FINAL DRIVE
SPECIAL TOOLS
PART NUMBER TOOL DESCRIPTION
2872608 Roll Pin Removal Tool
8700226
CV Boot Clamp Pliers
(earless type)
PU-48951 Axle Boot Clamp Tool
TORQUE SPECIFICATIONS
Wheel and Hub Torque Table
ITEM SPECIFICATION
Wheel Nuts
30 ft. Ibs. (41 Nm)
+ 90° (1/4 turn)
Front Hub Castle Nut 80 ft. Ibs. (108 Nm)
Rear Hub Castle Nut 80 ft. Ibs. (108 Nm)
Ball Joint Pinch Bolts 23 ft. Ibs. (31 Nm)
Front Brake Caliper
31-34 ft. Ibs. (42-46 Nm)
Mounting Bolts
Tie Rod End Fastener 42.5 ft. Ibs. (58 Nm)
Propshaft Support Bearing
16-18 ft. Ibs. (22-24 Nm)
Fasteners
Propshaft Bearing
65-75 in. Ibs. (7.3-8.4 Nm)
Set Screws
Front Gearcase
7-11 ft. Ibs. (10-15 Nm)
Cover Plate Screws
Front Gearcase
30 ft. Ibs. (41 Nm)
Mounting Bolts
Bearing Carrier to
50 ft. Ibs. (67.7 Nm)
Trailing Arm Bolts
Radius Rod to
50 ft. Ibs. (67.7 Nm)
Bearing Carrier Bolts
Rear Brake Caliper
30 ft.lbs. (41 Nm)
Mounting Bolts
7.2
FRONT BEARING CARRIER
Bearing Carrier Inspection I Removal
1. Elevate front of vehicle and safely support machine under
the frame area.
A
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping the top and bottom
of the tire firmly and checking for movement. The tire
should rotate smoothly without binding or rough spots.
3. Remove the (4) wheel nuts and remove the front wheel.
4. Remove the cotter pin and loosen the front wheel hub castle
nut. Remove the nut, and (2) cone washers from the front
wheel hub assembly.
5. Remove the fastener retaining the steering tie rod end to the
front bearing carrier.
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.