Special Tools; Torque Specifications; Front Bearing Carrier; Bearing Carrier Inspection / Removal - Polaris xp 2013 eps Service Manual

FINAL DRIVE

SPECIAL TOOLS

PART NUMBER
2872608
8700226
PU-48951
SPX Corp: 1-800-328-6657 or http://polaris.spx.com/

TORQUE SPECIFICATIONS

Wheel and Hub Torque Table
ITEM
Wheel Nuts
Front Hub Castle Nut
Rear Hub Castle Nut
Ball Joint Pinch Bolts
Front Brake Caliper
Mounting Bolts
Tie Rod End Fastener
Propshaft Support
Bearing Fasteners
Front Gearcase
Cover Plate Screws
Front Gearcase
Mounting Bolts
Bearing Carrier to
Trailing Arm Bolts
Radius Rod to
Bearing Carrier Bolts
Rear Brake Caliper
Mounting Bolts
7.2
TOOL DESCRIPTION
Roll Pin Removal Tool
CV Boot Clamp Pliers
(earless type)
Axle Boot Clamp Tool
SPECIFICATION
30 ft-lbs (41 Nm)
+ 90° (1/4 turn)
80 ft-lbs (108 Nm)
80 ft-lbs (108 Nm)
44 ft-lbs (60 Nm)
40 ft-lbs (54 Nm)
42.5 ft-lbs (58 Nm)
30-35 ft-lbs (41-47 Nm)
7-11 ft-lbs (10-15 Nm)
30 ft-lbs (41 Nm)
40 ft-lbs (54 Nm)
45 ft-lbs (61 Nm)
40 ft-lbs. (54 Nm)
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.

FRONT BEARING CARRIER

Bearing Carrier Inspection / Removal

1. Elevate front of vehicle and safely support machine
under the frame area.
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the (4) wheel nuts and remove the front
wheel.
4. Remove the cotter pin and loosen the front wheel hub
castle nut. Remove the nut, and (2) cone washers
from the front wheel hub assembly.
Cone
Castle Nut
Washers
Cotter Pin
CAUTION
Raise and
Support Vehicle