Selecting The Program Number - Ricoh LDD280 Service Manual

Selecting the Program Number

Program numbers have two or three levels.
1. Refer to the Service Tables to find the SP that you want to adjust before you
begin.
2. Press the Group number on the left side SP Mode window that contains the SP
that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to show the SP
number that you want to open. Then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item
that you want to set and press it. The small entry box on the right activates and
shows the below default or the current settings.
NOTE: Refer to the Service Tables for the range of allowed settings.
5. Do this procedure to enter a setting:
• Press
to toggle between plus and minus before using the keypad to
enter the appropriate number. The number you enter writes over the previous
setting.
• Press
to enter the setting. (The value is not registered if you enter a
number that is out of range.)
• Press "Yes" when you are prompted to complete the selection.
6. Press Exit two times to return to the copy window when you are finished.
Exiting Service Mode
Press the Exit key on the touch-panel.
SM
SERVICE PROGRAM MODE
5-9
C262S012.WMF
C262/C265