Tcs4 Delimiters; Configuring Integrated Voice Response (Ivr) Settings - Vidyo VidyoGateway Administrator's Manual

5. Configuring Your System
Note The VidyoGateway PIN delimiter can be set on the VidyoGateway
default is an asterisk *.

TCS4 Delimiters

The following are examples of TCS4 delimiters for various endpoints.
 Polycom and Lifesize endpoints use ##:
Example: 192.168.1.110##035001

Polycom PVX v.8.0.4 uses @:
Example: 035001@192.168.1.110
 Sony uses #:
Example: 192.168.1.110#035001
 Tandberg/Cisco does not support TCS4 delimiters, but uses @ as an inverted format URL
(Annex 0) style:
Examples: 035001@192.168.1.110, h323:35001@192.168.1.110
Note Tandberg C releases TC4.1.2 or later accepts the name@domain or name@IPAddress
dialing formats without being registered to a gatekeeper.
 Tandberg 2500 vB3.9 and Tandberg MCU 8+8 endpoints use ,:
Examples: 192.168.1.110,035001
 Codian MCI uses !:
Example: 192.168.1.110!035001

Configuring Integrated Voice Response (IVR) Settings

IVR is not available if Video Loopback is enabled. For more information, see
Loopback Settings.
When you dial into VidyoGateway from a Legacy device, a system of menus complete with text
and voice prompts guide you through the IVR interfaces. You can configure these IVR interfaces
using settings for Parameters, Prompts, and Import/Export IVR Media and Prompt Settings on the
corresponding tabs.
The following DTMF Modes are supported by Vidyo's IVR functions:
 H.245 signal (tone) outband

H.245 alphanumeric (string) outband
 RFC2833 (SIP Signaling with RTP payload)
 PCM waveform inband
93
Configuration
page. The
Configuring Video