Configuring Clusters - Vidyo VidyoGateway Administrator's Manual

5. Configuring Your System
The VidyoGateway setting for pointing to a specific VidyoPortal is done from the
VidyoPortal
tab. For more information, see
Active
VidyoGateway
Note: Controller 1 automatically sends calls to the first available
Active
VidyoGateway
The Standby Controller and Cluster Nodes must be associated with their corresponding Active
Controller. This is done by entering the specific Controller 1 Peer IP Address in to the Shared
Controller IP Address field for the Controller 2 and Cluster Node VidyoGateways on the
VidyoGateway Cluster tab. For more information, see

Configuring Clusters

The Cluster tab provides options to configure your VidyoGateway server as a Standalone,
Controller 1, Controller 2, or Cluster Node. The following sections cover these configurations in
more detail.
Each VidyoGateway server in your cluster must align to the following requirements:
 A public IP addresses must be used. This means none of the VidyoGateway servers in your
cluster can be NATed.
 If they are behind a firewall, it must permit Legacy ports for each VidyoGateway server in your
Cluster. This is usually configured as a set range of IP addresses in your firewall.

Each VidyoGateway server in your cluster must have IVR Enabled and identical IVR
configurations. For more information, see
Settings.
Configuring the VidyoPortal
Cluster #1
Standby
Cluster Node
VidyoGateway in your cluster.
Cluster #2 Standby
Cluster Node
Configuring Integrated Voice Response (IVR)
74
Settings.
Tenant: abc.mydomain.com
Vidyo Conference
Vidyo
User
Room Ext. 7001
Tenant: xyz.mydomain.com
Vidyo Conference
Vidyo
User
Room Ext. 7001
Configuring Clusters.
General >
Vidyo
Vidyo
User User
Vidyo Vidyo
User User