Configuring Controller 2 - Vidyo VidyoGateway Administrator's Manual

5. Configuring Your System

Configuring Controller 2

 Before configuring clusters, be sure to review
 When using VidyoGateway version 3.2 and later, your Services automatically propagate from
your Active Controller to the Standby Controller and Cluster Nodes. Therefore, the
does not display when accessed from your Standby Controller. To make configurations on the
tabs, you must access them from your Active Controller.
 If you choose to enable IVR on your Active Controller, you must also enable it on your Standby
Controller and all of the Cluster Nodes.
To configure Controller 2:
1. Log in to the Admin portal using your System Console account.
For more information, see
Cluster
2. Click the
3. Select Cluster from the Mode drop-down.
4. Select Controller 2 from the Role drop-down.
5. In the additional fields, configure Controller 2 as follows:

Enter a Controller 1 Hostname.
Provide the Hostname exactly as it's shown in System Console Option 1. Do not
provide an FQDN as the Peer Host Name.
For more information, see
 Enter a Controller 1 IP Address.
 Enter a Shared Controller IP Address. This is the address Legacy callers will use.
 Enter a notification email address.
Logging in to the Admin
tab.
Configuring Network Settings at the System
Understanding the Clustering
Portal.
79
Procedure.
Services
tab
Console.