Configuring H.323 Settings - Vidyo VidyoGateway Administrator's Manual

5. Configuring Your System

Settings made while only clicking Save accrue and are applied when you subsequently
click Save and Apply or reboot your VidyoGateway server.

For information about the Local SIP Port, see

Configuring H.323 Settings

H.323
The tab is used to configure your VidyoGateway H.323 protocol settings. However, before
you configure your H.323 settings, you must select whether you are using a Standalone
VidyoGateway (a single component acting as both Controller and VidyoGateway) or Clustered
VidyoGateways because the fields on the
set.
For more information about Standalone and Clustered VidyoGateways and about how to set either
configuration, see Understanding VidyoGateway Clusters
Note Values you provide in the fields on the
Cluster Nodes. Therefore, the
Node servers. To make configurations on the tabs, you must access them from your Active
Controller.
Configuring H.323 Settings When Using a Standalone VidyoGateway
When your VidyoGateway is configured as a Standalone VidyoGateway, the following settings are
H.323
available in the
For more information, see
To configure the H.323 settings when using a Standalone VidyoGateway:
1. Log in to the Admin portal using your System Console account.
For more information, see
H.323
2. Click the
The following screenshot shows the fields that display when the VidyoGateway has been
configured as a Standalone VidyoGateway using the
Clusters.
H.323
H.323
tab.
Configuring Clusters.
Logging in to the Admin
tab.
Configuring Advanced
tab change depending on which configuration you
and Configuring
H.323
tab are automatically propagated to your
tab does not display when accessed from your Cluster
Portal.
Cluster
60
Settings.
Clusters.
tab described in Configuring