Configuring Your Vidyo Server's Management Interface And Port - Vidyo VidyoGateway Administrator's Manual

5. Configuring Your System

Configuring Your Vidyo Server's Management Interface and Port

Your Vidyo server allows for the configuration of a secondary Ethernet interface that can be used to
access the management capabilities of the system. The secondary Ethernet interface is typically
on a segregated network from the main production interface allowing for increased security and
firewall protection.
You can move the Admin pages to the Management Interface so they are only accessible from that
location.
As shown in the following table, the Management Interface is referred to by different names on the
physical interface of the server and on the System Console and the VidyoGateway Admin Pages
Maintenance > Security > Ports
on the
Physical Interface
GB1
GB2
Note If the Management Interface is enabled, SNMP is only available on the Management
Interface.
The Management Interface should not be used to transfer any media.
The following sections show you how to enable the management interface in the system console
and then move the VidyoGateway Admin Pages to the Management Interface.
Enabling the Management Interface in the System Console
To enable the Management Interface:
1. Log in to the System Console.
For more information, see
the Default Password.
Enter 1 to configure IP Address.
2.
tab:
System Console and VidyoGateway Admin Page Ports Tab
PRODUCTION
MANAGEMENT
Logging in to the System Console of Your Server and Changing
141