Table of Contents
Advertisement
Terminal Server - User and Administration Guide
2.5 The Menu
System
16
The next prompt displayed is local>, which is the Command
Line Interface (CLI) prompt.
Note: If there are any problems, check the cable you are
using (this is the most common error). Port 1 is configured to
provide error messages should any problems occur. See
Troubleshooting & Maintenance (Appendix B) for more
information on problems.
You can now move to The Menu System.
You should now be at the Command Line Interface (CLI) of
the Terminal Server as designated by the local> prompt. If
you would like to continue in CLI mode refer to Appendix A ,
but we recommend the menu system.
Set the terminal emulation type and begin using the menus.
The following are the terminal options:
ansi, dumb, vt100, wyse50, wyse60, tvi925,
ibm3151, vt320, falco50, hp700
The default setting is 'dumb'. To set the menu interface to
your emulation simply type set term with your option.
Example:
local> set term ansi
To switch from the command line interface to the menu
interface, at the local> prompt enter:
set menu
The Connections Menu should now be displayed.
This menu displays the current state of the four possible
connections. There are no active connections.
Advertisement
Table of Contents
