Table of Contents
Advertisement
Terminal Server - User and Administration Guide
SU
TELNET
TEST
118
The show statistics command is used to display
any of the server statistics for troubleshooting
only (tcp, ip, udp, icmp, tty, eth, gateway ).
Example: show statistics tcp would show the
TCP parameters screen. You can add a delay
option which updates the screen every n seconds
such as: show stats tcp 3 (use ESC to quit).
Syntax:
su
Description:
This function allows the user to become the
administrator. When this command is entered
the Terminal Server prompts the user for the
admin password which is iolan by default
(please change for better security).
Syntax:
telnet [host] [port]
Description:
This function allows the user to make a telnet
connection to the specified host and port number.
If the user does not specify the port the server
defaults to port 23 which is the defined Unix
telnet port. If the host name is not defined then
the unit prompts the user for the host and port.
Syntax:
test [port port_number] [count <n none>]
Description:
This function causes the Terminal Server to run
a simple output test on the port. The Terminal
Server outputs a continuous stream of data in a
preset pattern. To stop the test press any key.
Advertisement
Table of Contents
