Table of Contents
Advertisement
The parameters are as follows:
The IP name or address of the authentication
Auth Host
host to validate incoming users.
The TCP port number of the authentication
Authentication
host, usually 23 (telnet) or 513 (Rlogin). A
Port
proprietary network number may be chosen to
provide a personal user validation scheme.
Default is 23 (telnet).
The user authentication prompt expected from
Login Prompt
the host by the server. Default is ogin:
The password prompt expected from the host by
Password
the server during the authentication connection.
Prompt
Default is ssword:
The string returned by the authentication host
Success
on successfully logging in. Default is last
Indication
String
The string returned by the authentication host
Failure
on a failed login attempt. Default is ogin
Indication
incorrect .
String
The maximum number of login attempts a user
Maximum
is allowed before the line is reset. For modem
Login
users the control lines DTR is toggled, the port is
Attempts
disabled for 3 seconds. Default is 3 .
Login Timeout This time defines the maximum time in seconds
for the user to enter authentication information,
once login time-out is exceeded the line is reset.
Default is 60 .
An option to keep the per port authentication
Disconnect
connection up during the clients' session. Default
Probe
is Yes . This allows a user connect time to be
measured by a simple 'do nothing' telnet session.
The Menu Interface
97
Advertisement
Table of Contents
