Table of Contents
Advertisement
Options
This is the destination IP address of the PPP/SLIP
Dst
connections. If blank, the remote host must
supply the IP address. If filled in, you designate
an assigned IP address to loan the remote host.
If the secure field on the Port Menu is No , this
can be overridden by the incoming host.
This is the subnet mask which controls the
Mask
range of IP addresses accessible from the port
(when using remote access).
This section of the menu deals mainly with the telnet options
and is the least used. Most of these options default to No .
This option specifies whether the server should
Keepalive
send keepalive messages to the host machines it
is connected to. Default is No .
Rlogin/Telnet This field specifies which of the two options
should be listed first in the Commands menu.
Default is telnet .
Debug options This field defines whether the telnet options
processing should be displayed and is used for
troubleshooting. Default is No .
This field defines whether the the server will
Map CR to
add a line feed to every carriage return on data
CR LF
going out to the serial port. Default is No .
When this field is set to Yes, the server displays
Hex data
all of the data it receives on this port in hex
format as well as in ASCII. This is used for
troubleshooting. Default is No .
Specifies the level of security to be applied to
Secure
the port in question. There are four selectable
values. Default is No .
The Menu Interface
85
Advertisement
Table of Contents
