Table of Contents
Advertisement
Terminal Server - User and Administration Guide
Flow Control
IP address
84
This field defines whether the server is using the
CLI/Menu
CLI or the menu interface. If the terminal is
configured for menu interface but the terminal
type is undefined or dumb, then the unit
remains in the CLI. Default will be Menu .
This field defines whether the terminal type
Reset Term
should be reset when a user logs out. This is a
very useful feature when the port is connected
to a modem. When a user logs out of the server
it resets the terminal type to dumb, so the next
person starts off in CLI mode and is able to set
the terminal type correctly. Default is No .
This section defines the various flow control options used by
the server. This section is always used. The parameters are:
This field defines which method of flow control
Flow Ctrl
to be used by this port, either XON/XOFF,
HARDWARE, BOTH, none or WANG. To use
HARDWARE flow control the correct cable must
be used (see Appendix C, Cabling Guide ).
WANG is a special option designed for WANG
terminal flow control applications. The default
is to use XON/XOFF .
This field allows you to define if the input flow
Input Flow
control is to be used. Default is Enabled .
This field allows you to define if the output flow
Output Flow
control is to be used. Default is Enabled .
This section of the menu deals with remote access and
modem sessions only. The parameters are as follows:
This is the source IP address of the port for PPP/
Src
SLIP connections. If blank, the Terminal Server
IP address is used.
Advertisement
Table of Contents
