Table of Contents
Advertisement
For dial-out
connections on
Windows
®
systems
6.3 Routing
Check our FTP sites for the latest information on dial-out
connections (under the Windows
For dial-out routing, you must have the proper routing entry
on all hosts in your local network that will communicate
with the remote site. In the case of a Unix system, you must
make an entry similar to the following (please check your
Unix manual for the proper syntax of the route command):
For a single host at the remote site:
route add <remote-ip-addr> <TSERVER-ip-addr> 2
For multiple hosts at the remote site:
route add net <remote-net-addr> <TSERVER-ip-addr> 2
The Terminal Server will dial into another piece of hardware,
log into that hardware and start a PPP session. Then the local
terminal server will act as a router and forward all IP traffic
destined outside its local network. In other words, the
Terminal Server will 'auto-dial' the Internet and act as the
router. In this example, the local network is: 206.131.227.0,
the ISP's network is: 206.189.134.0, the ISP's equipment that
you are dialing into is another Terminal Server (206.189.134.7)
and the local Terminal Server is: 206.131.227.5. The Terminal
Server gateway entries look like this:
** Administrator **
Entry Destination
1
[206.189.134.0
2
[default
3
[
4
[
________________________________________________________________________________
Figure 23: Gateway Menu screen.
Dial-out Modem Ports Setup
®
support directory).
GATEWAY MENU
Gateway
Netmask
] [206.189.134.7
] [default
] [206.189.134.7
] [default
] [
] [
] [
] [
REMOTE-ADMIN
]
]
]
]
49
Advertisement
Table of Contents
