Table of Contents
Advertisement
Port Setup Menu
and Beyond
Subnet mask
[
Ethernet address [00:80:d4:00:9e:
Language
[English ]
Identification
[
Lock
[Disabled]
Password limit
[5
CR to initiate
[Yes ]
SNAP encoding
[Disabled]
Figure 13: Commands pop-up menu (server confign).
Select the Save & Exit field and press the
options are Quit & Exit, which does not save the changes
before exiting this menu, Values, which will display the
optional values for this field if available, and Cancel, which
will take you back to this screen for more editing.
You have now set up the unit with a new IP address. This
should be confirmed with the message:
IP CHANGED—PLEASE REBOOT
Reboot the Terminal Server to activate the new IP address
using the reboot command. The IP address and/or subnet
mask are the only parameters that when changed necessitate
rebooting.
Your terminal server is now ready to configure for terminals
on multi-user systems or modems, printers and other devices.
The next sections deal with each of these. If you've got a
good feel for the menu system, you should proceed to the
section appropriate for your application.
If you'd like a full review of the menu system refer to Section
9, The Menu Interface later in this guide. For more
information about the Command Line mode, consult
Command Line Interface (Appendix A) .
Installing your IOLAN+
]
== Commands
===ernet interface [AUTO
| Save & Exit |
| Quit & Exit |
]
| Values
|
]
| Cancel
|
===============
]
key. Other
21
Advertisement
Table of Contents
