Table of Contents
Advertisement
________________________________________________________________________________
This option allows you to configure parameters affecting
the Server box, eg hosts table, other terminals.
RACK v4.02
a CDi
Figure 31: Connections Menu - Commands pop-up menu.
Pressing
at any of the four FREE fields presents the
Commands pop-up menu. If it was not free, the Telnet and
Rlogin fields would have been replaced by Close connection
and Resume connection signifying there is a session present.
The * ** FREE *** message would be replaced by the name or
IP address of the connected host.
The following describes the options that can appear in the
above menu:
This option allows you to make a connection to a
Telnet
specified host on the network using telnet . When
this command is selected, another pop-up menu
appears, giving you the host table list. In addition,
there is a specify host/IP address option you can
use for other IP addresses and host names.
This performs the same function as the Telnet
Rlogin
open command, but uses the Rlogin protocol.
While Telnet is the most commonly used protocol,
Rlogin can also be used (especially over WAN
connections because Rlogin packets are smaller).
The Menu Interface
Connection
Host
1
*** FREE **
=== Commands ===
2
*** FREE **
| Telnet
3
*** FREE **
| Rlogin
4
*** FREE **
| Port
| Admin mode ^A|
| CLI
| Lock
| Logout
================
^T|
^R|
^P|
|
|
^D|
TERMINAL SERVER
79
Advertisement
Table of Contents
