Refilling With Coolant - KTM 65 SX 2023 Owner's Manual

14 COOLING SYSTEM
14.5
86
H00119-10

Refilling with coolant

Warning
Danger of poisoning Coolant is harmful to health.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
K00211-10
400677-11
Condition
The engine is cold.
–
Position the motorcycle upright.
–
Place an appropriate container under the water pump cover.
–
1
Remove screw . Take off the radiator cap.
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Drain plug, water
pump cover
Main work
–
1
Make sure that screw
–
Position the motorcycle upright.
–
A
Add coolant to level .
Guideline
A
Distance above the radi-
ator fins
Coolant
–
Move the vehicle into the position shown and prevent it from
rolling away. Height difference
Guideline
B
Height difference
Info
For all of the air to be able to escape from the cooling
system, the vehicle must be raised at the front. If the
cooling system is poorly de-aerated, its cooling power
will be reduced and the engine may overheat.
–
Return the vehicle to the horizontal position.
–
A
Add coolant to level .
–
Mount the radiator cap.
Finishing work
–
Go for a short test ride.
–
Check the cooling system for leaks.
1
with a new seal ring.
M6 6 Nm (4.4 lbf ft)
is tightened.
10 mm (0.39 in)
0.55 l Coolant (
(0.58 qt.)
B
must be reached.
50 cm (19.7 in)
p. 109)