Display And Operation - Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual

15. MR-E- AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
Class No. Symbol
76 TL2 Internal torque limit 2
Set this parameter to limit servo motor torque on the assumption
that the maximum torque is 100[%].
When 0 is set, torque is not produced.
When torque is output in analog monitor output, this set value is the
maximum output voltage ( 8V).
77 For manufacturer setting
Don't change this value by any means.
78
79
80
81
82
83
84

15.5 Display and operation

15.5.1 Display flowchart
Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move
to the next screen.
To refer to or set the expansion parameters, make them valid with parameter No. 19 (parameter write
disable).
Name and function
POINT
For the alarm mode, parameter mode output signal (DO) forcible output
and test operation mode, refer to Chapter 6.
15 - 51
Initial Setting Control
Unit
value range mode
100 % 0
to
100
00
10000
10
10
100
100
100
0000
S T