Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual page 103

5. PARAMETERS
Class No. Symbol
Input signal selection 6 (CN1-7)
47 *DI6
Allows any input signal to be assigned to CN1-pin 7.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0 0
This parameter is unavailable when parameter No. 42 is set to
assign the control change signal (LOP) to CN1-pin 7.
This parameter is unavailable when parameter No. 48 is set to
assign the Forward rotation stroke end (LSP) to be assigned to CN1-
pin 7.
*LSPN LSP/LSN input terminal selection
48
Select the pins where the forward rotation stroke end (LSP) and
reverse rotation stroke end (LSN) will be assigned. If the signals
have already been assigned using parameter No. 42 to 47, this
parameter setting has preference.
However, if the forward rotation stroke end (LSP) is assigned at pin
6 of CN1 (default setting), the setting of parameter No. 46 takes
priority. Similarly, if the reverse rotation stroke end (LSN) is
assigned at pin 7 of CN1 (default setting), the setting of parameter
No. 47 takes priority. If the forward rotation stroke end (LSP) and
reverse rotation stroke end (LSN) are assigned at the same pin, the
forward rotation stroke end (LSP) takes priority while the reverse
rotation stroke end (LSN) is disabled.
0
Name and function
Position
control mode Input signals of
CN1-pin 7
Internal speed
selected.
control mode
0
Select the pin where the forward rotation stroke
end (LSP) will be assigned.
Set value Connector pin No.
0
CN1-5
1
2 CN1-4
3 CN1-6
4 CN1-7
5 CN1-3
Select the pin where the reverse rotation stroke
end (LSN) will be assigned. The settings are the
same as those of the first digit.
5 - 18
Initial Setting Control
Unit
value range mode
0000
Refer to
Name
and
function
column.
0403
Refer to
Name
and
function
column.
P S
P S